System Status


Total number of starts: 1189
Last device profile change time: 2018-05-09 17:23:03
Watchdog is: On
Watchdog tick: 12430251
Status Code (Base) : 0xC000
Status Code (Extended #1): 0x12000
Meter Last Alive Time: Tue, 08 Jan 2019 15:13:07 -0500
Meter Start Time: Tue, 08 Jan 2019 15:14:36 -0500
Meter Current Time: Wed, 23 Jan 2019 15:33:21 -0500
Alarm/email is: On
Total alarm send: 31430
Total alarm send successfully: 0
Total alarm send failed: 31430
Last Error at Line: -99997
Last SMTP error: 0
R: 1, B: 159, R-Index: 406, Check: 259
=DNP counter=29

SNTP disabled. Mode=Client, unicast. Port=123. Sync Rate=1 minutes. Timeout=20 seconds. Server 1 Errors=0. Server 2 Errors=0. Countdown=0. Last SNTP time=0-0-0 0:0:0.0. Server1=0.0.0.0. Server2=0.0.0.0. Delta_10=4294967295. Delta_10_Count=0. Delta_20=0. Delta_20_Count=0. Interface=1

EGD is Disabled. Port=65535. Interface=Auto.
Alarm Email is Enabled. Port=25. Interface=1.
MB TCP Polling is Enabled. Interface=1.
Default RT scan=0 switch=0 interface=1

Hardware RAM size=128M(ID=2), current firmware build for 128M RAM
#00, 0xB (irq4_err_ctr )
#01, 0x0 (irq4_frame_err_ctr )
#02, 0x128E1B96 (_free_1 )
#03, 0x1 (irq4_time_err_ctr )
#04, 0x0 (rms_checksum_err_ctr )
#05, 0x0 (wave_cap_out_of_buf_ctr)
#06, 0x0 (tran_buff_not_ready )
#07, 0x0 (missed_frames )
#08, 0x0 (missed_cycles )
#09, 0x0 (missed_channels )
#10, 0x0 (tranwave_out_of_buffer )
#11, 0x0 (pq_out_of_buffer )
#12, 0x0 (wave_data_mismatch )
#13, 0x0 (tran_data_mismatch )
#14, 0x88C4 (max_int_service )
#15, 0x51AA (max_window_service )
#16, 0xAD801B (wave_save_max_time )
#17, 0x1AA5F (frame_max_time )
#18, 0x16102 (frame_min_time )
#19, 0x0 (data_check )
#20, 0x0 (data_check_1 )
#21, 0x0 (data_check_2 )
#22, 0x4234 (tt_wave_caps )
#23, 0x0 (wave_cap_miss_1 )
#24, 0x0 (wave_cap_miss_2 )
#25, 0x0 (di_hs_count )
#26, 0x0 (di_board_count )
#27, 0x3CCC7 (di_task_count )
#28, 0x0 (chn142_bad_crc )
#29, 0x0 (header_bad_crc )
#30, 0x13 (time2cal_142_crc(us) )
#31, 0x15 (time2cal_header_crc(us))
First 6 debug xfer time array, DSP, PPC, Index, TT, Channel, prev Index, prev TT, prev channel
#0, 5488, 1, 0, 11, 80, 0, 0, 0
#1, 0, 0, 0, 0, 0, 0, 0, 0
#2, 0, 0, 0, 0, 0, 0, 0, 0
#3, 0, 0, 0, 0,_20_Count=0. Interface=1

EGD is Disabled. Port=65535. Interface=Auto.
Alarm Email is Enabled. Port=25. Interface=1

TIME CHANGED: [ Current Time - Reason - Set Time (DST) - SET Time msec : SNTP Time msec (SNTP Set only) ]
@0000/00/00 00:00:00.00 -- F -- 0000/00/00 00:00:00.00(0) -- 0.0000 : 0)